Keri-systems Doors.NET Quick Start Manual do Utilizador descarregar pdf (Página 5)

Part no. 01565-001 5 Version 1.0

o The Autoconfiguration Results tab will appear and all detected controllers will appear

in the Available Controllers section.

o By default, all controllers will be selected. An IP address must be assigned to each

controller. That can be done manually in the IP Address column or by entering a

range of IP Addresses in the area at the top of the section.

o Click Apply after entering the IP Address(es).

o The controller(s) will be assigned the given addresses and added to the NXT Gateway

o An “incorrect firmware” error message will appear in the Status Messages if the

controller firmware is below the required version. A firmware upgrade must be

completed before continuing.

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

Keri-systems Doors.NET Quick Start Manual do Utilizador Página 5